Breakerless SE Single Wire Ignition

The Breakerless SE Single Wire Ignition requires only one wire to operate, your existing original black wire that runs from the points in the distributor to the ignition coil. This not only simplifies installation but preserves the stock appearance of the original factory wiring and distributor. Similar ignition conversion systems on the market use two or three wires to operate, making installation more difficult and creating a non-stock appearance in your engine compartment.

The Breakerless SE Single Wire Ignition Kit comes with everything you will need to complete your installation. The kit includes 1 module, 1 two-piece vane assembly, all necessary mounting hardware, and a comprehensive instruction sheet.

Installation is easy. The entire system can typically be installed in less than 30 minutes.

There is no need to remove the distributor. The Breakerless SE Single Wire Ignition Kit is easily installed with the distributor in the vehicle. The entire system can be installed by most shade tree mechanics in less than 30 minutes.

The Breakerless SE Single Wire Ignition is compatible with factory and aftermarket tachs. A tach filter should not be required. However, if one was originally installed in the vehicle, it should be left in place. Some low cost imported and reproduction tachometers do a poor job of triggering from the coil negative signal and may require additional filtering to prevent erratic or inaccurate readings. The tachometer manufacturer should be contacted to resolve these types of problems.

The Breakerless SE Single Wire Ignition Kit is designed to be used with 1957 to 1974 GM, AMC, or Jeep V8 breaker point type distributors with windowed style distributor caps.

The Breakerless SE Single Wire Ignition is compatible with all original and stock GM coils. Most aftermarket and high performance coils are compatible as well. Be sure to follow the coil manufacturer's installation instructions carefully whenever installing a new coil.

The Ideal Coil Companion: Pair the Breakerless SE with our Restoration Plus Series GM Ignition Coil for a factory-correct look built to handle the demands of electronic ignition.